Triplett 9325 Datenblatt PDF herunterladen (Seite 9)

Capacitance Measurements

WARNING: To avoid electric shock, disconnect power to the

unit under test and discharge all capacitors before taking any

capacitance measurements. Remove the batteries and unplug

the line cords.

1.et the rotary function switch to the CAP position.

2.Insert the black test lead banana plug into the negative

(COM) jack.

Insert the red test lead banana plug into the positive (V) jack.

3.Touch the test leads to the capacitor to be tested.

4.Read the capacitance value in the display

Frequency/duty cycle Measurements (electronic)

1.Set the rotary function switch to “V” position.

2.Select ACV with the MODE button

3.Press the Hz/% button to indicate “Hz” in the display.

4.Insert the black lead banana plug into the negative COM

jack and the red test lead banana plug into the positive Hz jack.

5.Touch the test probe tips to the circuit under test.

6.Read the frequency on the display.

7.Press the Hz/% button again to indicate “%” on the display.

Read the % of duty cycle on the display.

Temperature Measurements

WARNING: To avoid electric shock, disconnect both test

probes from any source of voltage before making a

temperature measurement.

1.Set the function switch to TEMP.

2.Insert the Temperature Probe into the negative (COM) and

the V jacks, making sure to observe the correct polarity.

3.Select °C o°F with the MODE button.

4.Touch the Temperature Probe head to the part whose

temperature you wish to measure. Keep the probe touching

the part under test until the reading stabilizes (about 30

seconds).

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Triplett 9325 Datenblatt Seite 9